User's Manual

ManualsBrandsDell ManualsSoftwareDell System E-Support Tool Version 3.3

• DSET Collector and DSET CIM Provider

• DSET Collector Only

• DSET CIM Provider Only

NOTE

: You must be logged in as root to install DSET.

1. At the Linux shell prompt, run the ./dell-dset-lx(bit)-(Version Number).bin file.

The License Agreement is displayed along with the following message:

Do you agree to the above license terms? ('y' for yes | 'Enter' to exit):

2. Enter y.

The installation types are displayed. The following table provides the installation types:

Table 4. :Installation Types

Type Installation Option Description

1 Install/Upgrade DSET Collector and DSET

CIM Provider

Select this option to permanently install DSET

Collector and DSET CIM Provider.

2 Install DSET Collector Only Select this option to permanently install DSET

Collector only.

3 Install DSET CIM Provider Only Select this option to permanently install DSET

CIM Provider only.

NOTE

– For DSET version 2.2 or lower, installation type 1 is displayed.

– If DSET 3.2 Collector and Provider or Collector only or CIM Provider only is currently installed in the

system, then installation types 1, 2, and 3 are displayed.

– For DSET 3.3:

* If Collector only is currently installed in the system, then installation type 3 is displayed.

* If CIM Provider only is currently installed in the system, then installation type 2 is displayed.

3. Enter the

<option number> to select the required installation type.

Install/Upgrade DSET Collector and DSET CIM Provider or DSET CIM Provider

only

option is selected, then during installation if SFCB or OpenPegasus is not installed or running, the following

message is displayed:

The Small Footprint CIM Broker (SFCB) is a network service that enables

remote collection of system configuration information.

To perform the option that you selected, it is necessary to install and

start this service and leave it running in background for future

configuration collection.

Continue installing/activating the SFCB on this system to listen for

incoming collection requests from clients. Do you want proceed[y|n]?

4. Enter y.

If OpenPegasus is installed and running, the following message is displayed:

DSET collects the Hardware data via Common Information Model Object

Model(CIMOM): tog-pegasus, which is already present on this system, Please

enter the Administrator/Root password to validate the existing tog-pegasus

5. Enter the root credentials of the system when the following message is displayed:

Please enter "root" password:

Wait for the installation to complete. The following messages are displayed based on the selected installation type: