User's Manual

NOTE

: If you do not want to upgrade, click Cancel to exit the installer.

3. Click

Upgrade to upgrade to DSET version 3.3.

The License Agreement window is displayed.

NOTE

: For upgrading from versions 2.2 and lower, only DSET Collector and DSET CIM Provider permanent

install option is available.

4. Follow steps 3 to 12 provided in Using GUI For Windows Operating System.

Using CLI

To automatically upgrade to DSET 3.3 using CLI, at the prompt, run the command:

• Dell_DSET_(Version Number.exe — This invokes the GUI.

• Dell_DSET_(version number).exe ADDLOCAL=<full/collector/provider>

INSTALLDIR=<location> /qn — This performs silent installation that does not display any graphical

progress bar.

NOTE:

• ADDLOCAL parameter in the command is optional.

• For version 3.2 and later, while upgrading, if

ADDLOCAL parameter is not included in the command, then

only the installed component is upgraded.

• For version 2.2 or lower, if Dell_DSET_(version number).exe /qn is run, then both DSET

Collector and CIM Provider are upgraded.

Where:

full

= Full installation of both DSET Collector and DSET Provider on the local system

collector = Installation of DSET Collector only for remote collection

provider = Installation of DSET Provider only for remote collection from a remote system

If DSET 3.2 is currently installed in the system, use the following options to upgrade to DSET 3.3.

Table 1. : Upgrading scenarios from DSET 3.2 to DSET 3.3

Full (Collector and Provider) Collector Provider

Full (Collector and Provider) Yes Yes Yes

Collector Yes Yes Yes

Provider Yes Yes Yes