Owner's Manual

location = optional installation path
/qn = Silent installation that does not display any graphical progress bar
Clearing Hardware Logs
DSET clears Dell hardware logs (Embedded System Management logs) from the system without permanently installing the
application. You can clear hardware logs using the installer or from the Start menu.
Using Installer :
To clear hardware logs from the system:
NOTE : This does not install DSET permanently.
1. Run the Dell_DSET_3.3.0.x.exe file.
The Welcome to the Dell System E-Support Tool (3.3) Installation Wizard window is displayed.
2. Click Next to proceed through license agreement and readme information until the Installation Type window
appears.
3. Select Clear Hardware Log Only and click Next .
The User Information window is displayed.
4. You may enter your Full Name and Organization Information . This is optional.
5. Click Next .
The Ready to Install the Application window is displayed.
6. Click Next .
The Updating System window is displayed. If the installed OpenManage Server Administrator version is not 5.5
through 7.1, then "Dell System E-Support Tool 3.3 cannot be installed. The installed version of OpenManage
Server Administrator is incompatible. Update your system with Server Administrator version 5.5 through 7.1 and
run the setup program." message is displayed and the hardware logs are not cleared.
Install a compatible version of the Server Administrator and run the Dell_DSET_(Version Number).exe file to clear
the hardware logs. After some time, the command window is displayed with the following message:
7. Enter Y to clear the logs. The following messages are displayed:
8. Press any key.
The command window closes and the Click the Finish button to exit this installation. window is displayed.
9. Click Finish to close DSET.