Owner's Manual

The DSET (Version Number) is already installed window is displayed.
NOTE : If you do not want to upgrade, click Cancel to exit the installer.
3. Click Upgrade to upgrade to DSET version 3.3.
The License Agreement window is displayed.
4. Click Next to proceed through license agreement and readme information until the Installation Type window
appears.
NOTE: For upgrading from versions 2.2 and lower, only DSET Collector and DSET CIM Provider permanent install
option is available.
5. Follow steps 3 to 8 in Permanently Installing DSET and Generating Report section of the Readme.
Using CLI
To automatically upgrade to DSET 3.3 using CLI, at the prompt, run the command:
 Dell_DSET_(Version Number).exe — This invokes the GUI.
 Dell_DSET_(version number).exe ADDLOCAL=<full/collector/provider> INSTALLDIR=<location> /qn — This performs
silent installation that does not display any graphical progress bar.
NOTE :
o ADDLOCAL parameter in the command is optional.
o For version 3.2 and later, while upgrading, if ADDLOCAL parameter is not included in the command, then
only the installed component is upgraded.
o For version 2.2 or lower, if Dell_DSET_(version number).exe /qn is run, then both DSET Collector and
CIM Provider are upgraded.
Where:
full = Full installation of both DSET Collector and DSET Provider on the local system
collector = Installation of DSET Collector only for remote collection
provider = Installation of DSET Provider only for remote collection from a remote system
For Linux
To automatically upgrade to DSET 3.3 on Linux operating system:
1. At the Linux shell prompt, run the ./dell-dset-lx(bit)-3.3.0.x.bin file.
The License Agreement is displayed along with the following message:
2. Enter y.
Dell System E-Support Tools (DSET) options are displayed
3. Enter <option number> to select Install/Upgrade DSET Collector and DSET CIM Provider option. The following
messages are displayed:
4. Enter y.
If SFCB or OpenPegasus is not installed or running, the following message is displayed: