Owner's Manual

8. Press any key.
The command window closes and the Dell System E-Support Tool (3.2) has successfully cleared the ESM logs
window is displayed.
9. Click Finish to close DSET.
Using GUI :
To clear hardware logs:
1. Navigate to DSET 3.2 -> Clear ESM Logs in the Start menu .
The Clear ESM Logs command window displays the following message:
2. Enter Y to clear the logs. The following messages are displayed:
3. Press any key.
The command window closes.
Extracting MSI Package For Large Site Automated Deployment
To extract the MSI file out of DSET EXE:
1. Run the Dell_DSET_3.2.0.x.exe file.
The Welcome to the Dell System E-Support Tool (3.2) Installation Wizard window is displayed.
2. The MSI is already extracted at the following location:
C:\Program Files\Common Files\Wise Installation Wizard
NOTE : The MSI location for Windows (x86) systems is C:\Program Files\Common Files\Wise Installation Wizard and
for Windows (x86_64) systems is C:\Program Files (x86)\Common Files\Wise Installation Wizard.
There should be only one MSI file that can be copied from this folder and renamed if required.
3. Cancel the DSET installer to remove the embedded MSI package.
For Linux:
Creating One-time Report (Zero Footprint)
DSET enables you to generate a configuration report without permanently installing DSET. This is also known as "Zero
Footprint" report collection. After the report is generated and saved on the system, all files used to create the report are
removed from the system.