Owner's Manual

Using the CLI :
To install DSET, run the following command:
Dell_DSET_3.2.0.x.exe INSTALL= <full/collector/provider> INSTALLDIR=<location> /qn
Where:
Full = Full installation of both DSET Collector and DSET Provider on the local system
Collector = Installation of DSET Collector only for remote collection
Provider = Installation of DSET Provider only for remote collection from a remote system
INSTALLDIR = optional installation path /qn = Silent installation that does not display any graphical progress bar
Clearing Hardware Logs
DSET clears Dell hardware logs (Embedded System Management logs) from the system without permanently installing the
application. You can clear hardware logs using the installer or from the Start menu.
Using Installer :
To clear hardware logs from the system:
NOTE : This does not install DSET permanently.
1. Run the Dell_DSET_3.2.0.x.exe file.
The Welcome to the Dell System E-Support Tool (3.2) Installation Wizard window is displayed.
2. Click Next to proceed through license agreement and readme information until the Installation Type window
appears.
3. Select Clear Hardware Log Only and click Next .
The User Information window is displayed.
4. You may enter your Full Name and Organization information. This is optional.
5. Click Next .
The Ready to Install the Application window is displayed.
6. Click Next .
The Updating System window is displayed. After some time the command window is displayed with the
following message:
7. Enter Y to clear the logs. The following messages are displayed: