Owner's Manual

For silent Zero FootPrint report collection, run the command:
Permanently Installing DSET
You can permanently install the following DSET components:
 DSET Collector and DSET CIM Provider
 DSET Collector Only
 DSET CIM Provider Only
Installing or Upgrading DSET Collector and DSET CIM Provider
To permanently install or upgrade DSET on the local system:
NOTE : You must be logged in as root to install or upgrade DSET.
1. At the Linux shell prompt, run the ./dell-dset-lx(bit)-3.2.0.x.bin file.
The License Agreement is displayed along with the following message:
2. Enter y.
The installation types are displayed.
3. Enter 3 to select Install/Upgrade DSET Collector and DSET CIM Provider option.
If SFCB or OpenPegasus is not installed or running, the following message is displayed:
4. Enter y.
If OpenPegasus is installed and running, the following message is displayed:
5. Enter the root credentials of the system when the following message is displayed:
6. Wait for the installation to complete. The DSET installation completed successfully message is displayed.
DSET is installed at the /opt/dell location by default.
For silent installation, run the command:
Installing DSET Collector
To permanently install DSET Collector:
NOTE : You must be logged in as root to install DSET Collector.
1. At the Linux shell prompt, run the ./dell-dset-lx(bit)-3.2.0.x.bin file.
The License Agreement is displayed along with the following message: