Quick Start Manual

■ Navigate to the location where you downloaded the SQL Express SP3 setup
file.
■ Click OK.
■ Click Next.
19
If you are prompted, select how the Symantec Device Driver Installer should
install device drivers for the tape storage devices that are connected to the
server, and then click Next.
Symantec recommends that you select Use Symantec device drivers for all
tape devices.
20
If you are prompted, enter information or choose settings for the additional
options that you want to install, and then click Next after each selection.
21
Read the Backup Exec installation summary, and then click Install.
The installation process takes several minutes to complete. During the process,
the progress bar may not move for several minutes.
22
When the installation is complete, you can run LiveUpdate, view the readme,
and create a shortcut to Backup Exec on the desktop.
23
Click Finish to close the installation wizard.
24
If Restart System appears, restart the computer in order for the configuration
to take effect.
Installing additional Backup Exec options to the local
media server
You can install agents and options when you install Backup Exec. However, if you
have already installed Backup Exec and want to install additional options, review
the documentation for those options to ensure that your system meets all minimum
requirements. The Backup Exec services may be stopped while the additional
options are installed. If any active jobs are running, you are prompted to stop
them, or to wait for the jobs to finish.
See “Installing Backup Exec to a local computer” on page 7.
Note: If you install Backup Exec through Terminal Services and the installation
media is on a shared drive (network share) you must install using a UNC path.
Installation by mapped drives is not supported.
11Installing Backup Exec
Installing additional Backup Exec options to the local media server