Users Guide

30 Installing Oracle RAC 10g R2 Using ASM
3 In the Specify Home Details window, select OraDB10g_home1 from the
drop-down menu and click
Next .
4 In the Specify Hardware Cluster Installation Mode window, click Next .
5 In the Product-Specific Prerequisite Checks window, click Next .
6 In the Oracle Configuration Manager Registration window, click Next .
7 In the Summary window, click Install .
During the installation, the following error may be displayed:
Error in
writing to file oci.dll.
To avoid this error, perform the following steps:
a Cancel the patchset installation.
b Rename the %Oracle_home%\BIN directory to \bin_save .
c Reboot the system.
d After the system reboots, rename the \bin_save file to \bin .
e Run the setup.exe file from the patchset folder. Allow all the Oracle
default services to run.
8 In the End of Installation window, perform all the steps that the Summary
tab displays.
9 In the End of Installation window, click Exit .
10 Click Yes to exit from the OUI.
Configuring the Listener
This section describes the steps to configure the listener, which you need to
connect to the database from a remote client.
NOTE: You must install the patch before you follow the procedure in this section.
Perform the following steps on node 1:
1
Click Start , select Run , and type netca and click OK .
2 In the Real Application Clusters, Configuration window, select Cluster
configuration
and click Next .
3 In the Real Application Clusters, Active Nodes window, select Select all
nodes
and click Next .
4 In the Welcome window, select Listener configuration and click Next .