Owner's Manual

Installing and Configuring the Operating System 19
5 When the installation procedure is completed, the Welcome to Windows
window is displayed.
a Shut down the system, reconnect all external storage devices, and start
the system.
b In the Welcome to Windows window, press <Ctrl><Alt><Delete>
to continue. The
Log On window is displayed.
c In the Password field, type the administrator password that you
created in
step 4 in this procedure and click OK .
You are prompted to insert the Microsoft Windows Server CD2 . You
can insert the Windows Server CD2 or click
Cancel .
NOTE: If you insert the Windows Server CD2, follow the prompts through the
normal installation process. The following process assumes you are not
inserting the Windows Server CD2.
d Click Cancel . A message is displayed informing you that media on
Windows Server CD2 is not going to be installed.
e Click OK. You are prompted to configure Windows Server Post-Setup
(optional).
f Click Finish . You are prompted to close the page.
g Click Yes . The Manage Your Server Windows Management window is
displayed.
h Close the window.
NOTE: To use the Broadcom Advanced Control Suite 3 (BACS), install
Microsoft .NET Framework 2.0. The Microsoft .NET Framework 2.0 can be
downloaded from microsoft.com.
Installing Windows Server 2008 SP2
1 If you chose Microsoft Windows Server 2008 x64 (64 bit Edition) during
the Dell Systems Build and Update Utility installation process then on the
reboot the Systems Build and Update Utility installer will prompt to insert
a valid Windows Server 2008 media into DVD drive. Insert the
Windows
Server 2008 SP2
media into DVD drive and click OK .
2 Click OK on the Valid Microsoft Windows Server 2008 SP2 media
window to start the installation.