Manualshelf

Users Guide

ManualsBrandsDell ManualsAnalyticsSupportAssist Enterprise 1.x
111112113114115116117118119120
Table Of Contents
Related references
Preferences on page 194
Enabling or disabling the collection of identity
information
Prerequisites
You must be logged in to SupportAssist Enterprise with elevated or administrative privileges. See SupportAssist Enterprise user
groups on page 130 and Granting elevated or administrative privileges to users on page 132.
About this task
The system information that is collected by SupportAssist Enterprise includes identity information (PII) such as the complete
configuration snapshot of systems, hosts, and network devices that can contain host identification and network configuration
data. In most cases, part or all of this data is required to properly diagnose issues. If the security policy of your company
restricts sending identity data outside of the company network, you can configure SupportAssist Enterprise to filter such data
from being collected and sent to Dell.
The following identity information can be filtered when collecting the system information from a device:
● Host name
● IP address
● Subnet mask
● Default gateway
● MAC address
● DHCP server
● DNS server
● Processes
● Environment variables
● Registry
● Logs
● iSCSI data
● Fibre Channel data — host World Wide Name (WWN) and port WWN
NOTE:
When the Include identification information in collections option is cleared, some of the data about your
company network (including the system log) is not transmitted to Dell. This may impede Technical Support from resolving
issues that may occur on your devices.
NOTE: If your devices have an active ProSupport Plus, ProSupport Flex for Data Center, or ProSupport One for Data
Center service contract, when the Include identification information in data sent to Dell option is disabled, you will not
receive some reporting information about your devices.
Steps
1. Point to Settings and click Preferences.
The Preferences page is displayed.
2. In Identification Information Settings, depending on your requirement, select or clear the Include identification
information in data sent to Dell option.
NOTE: By default, the Include identification information in data sent to Dell option is selected.
NOTE: If you clear the Include identification information in data sent to Dell option, the settings for collection of
logs, diagnostic data, and support data are disabled automatically. Therefore, collections that are sent to Dell from your
devices do not include certain categories of data.
NOTE: If you have disabled the collection of identity information from devices, the identity information such as
hostname, IP address, and so on, are replaced by tokenized values in the collected system information. The tokenized
values are represented as TOKENn—for example, TOKEN0, TOKEN1, or TOKEN2.
Configuring collection settings 111