Users Guide

Table 10. Selecting a device type (continued)
Device Type Devices that you can add
● PowerEdge VRTX
● PowerEdge FX2/FX2s
Fluid File System (FluidFS)
● Storage PS Series with FluidFS
● Storage MD Series with FluidFS
● Storage SC Series with FluidFS
iDRAC 12th and later generations of PowerEdge servers
NOTE: To add an iDRAC, you must provide the iDRAC IP
address of the server.
Networking
● PowerConnect
● Force10
● Networking
● Networking X-Series switches
● Networking Wireless Controllers Mobility Series
Peer Storage (PS) / EqualLogic Storage PS Series arrays
PowerVault Storage MD Series arrays
Server / Hypervisor 9th or later generation of PowerEdge servers running:
● Windows
● Linux
● VMware ESX or ESXi
● Citrix XenServer
● Oracle Virtual Machine
● Microsoft Hyper-V
NOTE: To add a Server / Hypervisor, you must provide
the operating system IP address of the server.
NOTE: If SupportAssist Enterprise is installed on a Linux
operating system, adding servers running Windows is not
supported.
Software
● HIT Kit / VSM for VMware
● SAN HQ
● vCenter
● SCVMM
NOTE: If SupportAssist Enterprise is installed on a Linux
operating system, adding SCVMM and SAN HQ is not
supported.
Solution XC Web-Scale Converged Appliance
Storage Center (SC) / Compellent Storage SC Series solutions
Adding a single device
You can add a device individually based on the device type. The available device types that you can add are as follows:
● Chassis
● Fluid File System (FluidFS)
● iDRAC
● Networking
● Peer Storage (PS) / EqualLogic
38
Adding devices