Users Guide

Table 72. Error code appendix (continued)
Error code Error message Possible resolution
SA-0130 SupportAssist Enterprise is unable to add the
device_name because the SSL encryption level of the
device is set to 256 bit or higher.
For troubleshooting steps, see Unable to add the
device.
SA-0135 SupportAssist Enterprise is unable to add the
device_name because the device type that you
selected is incorrect.
Ensure that you select the correct device type and
then try again.
SA-0140 SupportAssist Enterprise is unable to add the
device_name because a connection to the device
was unsuccessful.
Perform the following:
● Ensure that the required ports are open on the
device. For information on the required ports, see
the SupportAssist Enterprise Version 1.2 User's
Guide at Dell.com/ServiceabilityTools.
● Ensure that you have selected the correct device
type. Verify if the device is supported by
SupportAssist Enterprise. For the list of supported
device models, see the SupportAssist Enterprise
Version 1.2 Support Matrix at Dell.com/
ServiceabilityTools.
SA-0145 SupportAssist Enterprise is unable to add the
device_name because the device credentials were
not provided.
Enter the device credentials and then try again.
SA-0150 SupportAssist Enterprise is unable to add the
device_name because the device credentials were
either not provided or incorrectly provided.
1. Enter the device credentials.
2. Ensure that the device credentials are correct.
SA-0155 SupportAssist Enterprise is unable to add the
device_name because it is a Storage PS Series
member IP address.
Try adding the device again with the Peer Storage PS
Series group IP address.
SA-0160 The IP address that you have entered is a Dell Peer
Storage/Storage PS Series member IP address.
Ensure that you add the device by using the group IP
address.
SA-1005 SupportAssist Enterprise is unable to edit the
credentials of the device_name because an attempt
to connect to the device is unsuccessful.
Make sure that both the system running SupportAssist
Enterprise and the device are connected to the
network, and then retry the operation.
SA-1010 SupportAssist Enterprise is unable to edit the
credentials of the device_name because of an
unexpected error.
Verify the following and then retry editing the device
credentials:
● Make sure that the required services are running
on the device. For information on the required
services, see the Online Help.
● Make sure that the entered credentials have
administrator or root privileges.
SA-1015 SupportAssist Enterprise is unable to edit the
credentials of the device_name because the user
name or password is incorrect.
Verify the user name and password, ensure that the
user account has administrator/root privileges, and try
again. If the problem persists, contact your network
administrator for assistance.
SA-1025 SupportAssist Enterprise is unable to edit the
credentials of the device_name because the entered
it is already in use by another device.
Enter any other name, and then retry editing the
device credentials.
SA-1030 SupportAssist Enterprise is unable to edit the device
credentials because the entered credentials do not
have superuser rights.
Enter the credentials that have superuser rights, and
then retry saving the device credentials.
SA-1035 SupportAssist Enterprise is unable to update the
device credentials because a required service is
disabled on the device.
Make sure that the required services are running on
the device, and then retry editing the device
Error code appendix 231