Users Guide

● You must have read-write access to the system drive of the target device.
About this task
Configuring SNMP settings sets the alert destination of a device, and ensures that alerts from the device are forwarded to the
server where SupportAssist Enterprise is installed. If the SNMP settings of a device are not configured, the status column on
the Devices page displays an appropriate message. You can use the Configure SNMP option to automatically configure the
SNMP settings of a device.
NOTE: Configuring SNMP by using SupportAssist Enterprise is not supported on devices running the following operating
system or hypervisors:
● Oracle Enterprise Linux
● VMware ESXi
● Oracle Virtual Machine
Steps
1. Point to Devices and click View Devices.
The Devices page is displayed.
2. Select the device where you want to configure the SNMP settings.
NOTE: If SupportAssist Enterprise does not support the configuration of SNMP on the device that you have selected,
the Configure SNMP option is disabled.
The device overview pane is displayed at the right side of the Devices page.
3. From the Tasks list, select Configure SNMP.
Figure 33. Configure SNMP option
Maintaining SupportAssist Enterprise capability
107