Quick Reference Guide

Troubleshooting 291
is missing an essential file. To remove and then reinstall the program:
Windows Vista
1 Click Start → Control Panel → Programs → Programs and Features .
2 Select the program you want to remove.
3 Click Uninstall .
4 See the program documentation for installation instructions.
Windows XP
1 Click Start → Control Panel → Add or Remove Programs → Programs and Features .
2 Select the program you want to remove.
3 Click Uninstall .
4 See the program documentation for installation instructions.
drive letter :\ IS NOT ACCESSIBLE. THE DEVICE IS NOT READY — The drive
cannot read the disk. Insert a disk into the drive and try again.
I
NSERT BOOTABLE MEDIA — Insert a bootable CD or DVD.
N
OT ENOUGH MEMORY OR RESOURCES. CLOSE SOME PROGRAMS AND TRY
AGAIN — Close all windows and open the program that you want to use. In some
cases, you may have to restart your computer to restore computer resources. If so, run
the program that you want to use first.
O
PERATING SYSTEM NOT FOUND — Contact Dell (see"Contacting Dell" on
page 337).
IEEE 1394 Device Problems
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
NOTE: Your computer supports only IEEE 1394a standard.
E
NSURE THAT THE CABLE FOR THE IEEE 1394 DEVICE IS PROPERLY INSERTED INTO
THE DEVICE AND INTO THE CONNECTOR ON THE COMPUTER
ENSURE THAT THE IEEE 1394 DEVICE IS ENABLED IN SYSTEM SETUP — See
"Working With Options on the System Setup Program Screen" on page 308.
E
NSURE THAT THE IEEE 1394 DEVICE IS RECOGNIZED BY WINDOWS —
Windows Vista
1 Click Start → Control Panel → Hardware and Sound .
2 Click Device Manager.