White Papers
Table Of Contents
- 1 Introduction
- 2 VMware SRM terminology
- 3 Overview and prerequisites
- 4 Configuring array based replication
- 5 Installation and configuration of VMware SRM
- 6 SRM protection groups
- 7 Recovery plans
- 8 Testing
- 9 Recovery
- 10 Failback
- 11 Considerations for guest iSCSI connected volumes
- 12 Summary
- A Technical support and resources
13 Disaster Recovery with Dell PS Series SANs and VMware vSphere Site Recovery Manager | TR1073
4. Configure the replication schedule that meets the bandwidth and recovery needs for the VMs on that
Datastore volume and click Next. For more information on Replication considerations, see the PS
Series Administration Guide and Dell EqualLogic Auto-Replication: Best Practices and Sizing Guide.
5. Verify the summary of the schedule and click Finish. Follow the same procedure on all the Datastore
volumes that host VMs that are to be protected in SRM.
Once the replication partnership is configured between the protected site and the recovery site, and every
Datastore volume that needs to be protected has been configured for replication, including having an active
replication schedule, you can proceed with the configuration of SRM. These steps must be repeated for each
volume added to the virtual environment that will be hosting VMs and need SRM protection.