Install Guide

17 Citrix XenServer with Dell SC Series Storage Configuration and Deployment | 3132-CD-V
4.2.2 Assign NIC functions using the XenCenter management GUI
To perform these steps using the CLI rather than the XenCenter GUI, see section 4.2.3. Be sure Multipathing
has been enabled as shown in section 3.4.1.
4.2.2.1 Optional steps: implementing Jumbo Frames
1. In the XenCenter management GUI, navigate to the Infrastructure view, navigate through the
objects, select the desired XenServer host, select the Networking tab, select the desired Network
from the list, and click Properties.
2. Select Network Settings, input the MTU of 9000 (default value is 1500), and deselect the checkbox
so this network will not be added to new VMs.
3. Repeat steps 1–2 for each additional network dedicated for iSCSI storage.