Setup Guide

Figure 4. Align the Cable Management Tray
6 Slide the 1U cable management tray into the rails until it locks into place.
Mount the Expansion Enclosure
Install the rails in the rack, and mount the SCv360 expansion enclosure on the rails.
Prerequisite
Required materials:
• Screwdriver (034-000-193)
• Six clip nuts (106-569-307)
• Two M5 x 10 mm Phillips pan-head screws (106-002-452)
• Two M5 x 16 mm Phillips pan-head screws (106-002-453)
Steps
1 Adjust the length of the expansion enclosure rack rails to t the rack.
2 Attach the right rail to the back post of the rack.
a Align the right rail with the lower two U spaces of the 4U mounting location.
b With the release latch on the outer part of the rack post, place the catch
mechanism over the post.
c Push the rail back to secure the rail to the rack post.
An audible click indicates that the rail is secure in the post.
12
Setting Up the Expansion Enclosure