Owners Manual
Figure 7. Installing and Removing the Bezel
1 Keylock 2 Front bezel
Install the Front Bezel
To secure the storage system, install the front bezel.
1 Hook the right end of the replacement bezel onto the front panel of the storage system.
2 Insert the left end of the bezel into the securing slot until the release latch locks into place.
3 Secure the bezel with the keylock.
Hard Drives
The SCv3000 and SCv3020 storage system supports hot-swappable hard drives.
A minimum of 4 SSDs or 7 drives must be installed in the chassis or in an expansion enclosure. The SCv3000 and SCv3020 storage system
supports a maximum of 16 or 30 drives installed in the chassis. The drives are installed from left to right, and then top to bottom. The rst
row of drives are numbered from 0–4 from left to right, the second row of drives are numbered from 5–9 from left to right, and so on.
Dell Storage Manager identies drives as XX-YY, where XX is the number of the unit ID of the storage system and YY is the drive position
inside the storage system.
Figure 8. SCv3000 Storage System Drive Numbering
Replacing Storage System Components
15