Deployment Guide

Disconnect the SCv300 and SCv320 Expansion Enclosure

from the A-Side of the Chain

Disconnect the A-side cables from the expansion enclosure that you want to remove.

Steps

1. Disconnect the A-side cable (shown in orange) from expansion enclosure 1: top EMM, port 1. The B-side cables continue to carry I/O

while the A-side is disconnected.

2. Remove the A-side cable between expansion enclosure 1: top EMM, port 2 and expansion enclosure 2: top EMM, port 1.

Figure 68. Disconnecting the A-Side Cables from the Expansion Enclosure

Storage system 2. Storage controller 1

3. Storage controller 2 4. Expansion enclosure 1

5. Expansion enclosure 2

3. Connect the A-side cable to expansion enclosure 2: top EMM, port 1.

Adding or Removing Expansion Enclosures