Deployment Guide

Set the Password and Finish the Installation

If you are connected to a Data Collector, the Security tab opens after configuring the network settings.

Prerequisites

This section applies only if you are connected to a Data Collector.

Steps

1. Type a password for the Storage Center Admin user in the New Password field.

2. Retype the password for the Storage Center Admin user in the Confirm Password field.

3. Click Next.

The Storage Center Summary page opens.

4. Verify that the Storage Center settings are correct.

5. If the configuration information is correct, click Next.

If the configuration information is incorrect, click Back and provide the correct information.

NOTE: After you click the Next button, the configuration cannot be changed until after the Storage Center is fully

deployed.

The Installation Complete page opens.

6. Click Finish.

The Configure tab of the Initialize Storage Center wizard is displayed.

Complete the Installation

Use the Installation Complete page to connect to the Storage Center after the settings on the Summary page are applied to the Storage

Center.

Steps

1. Click Connect.

The Unisphere interface opens in a web browser.

2. Log into Unisphere to continue Storage Center initialization:

a) Type Admin in the User Name field.

b) Type the password for the Storage Center Admin user in the Password field.

c) Click Log In.

The Configure tab of the Initialize Storage Center wizard is displayed.

Deploying the Storage Center Using Storage

Manager Client

Setting up a Storage Center using the Discover and Configure Uninitialized Storage Centers wizard and the host setup wizards requires

64-bit versions of the following operating systems:

• Red Hat Enterprise Linux 6 or later

• SUSE Linux Enterprise 12 or later

• Windows Server 2008 R2 or later

Install and Use the Storage Manager Client

Start the Storage Manager Client as an Administrator to run the Discover and Configure Uninitialized Storage Centers wizard.

Steps

1. Install the Storage Manager Client on a host server.

To discover and configure a Storage Center, the software must be installed on a host server that is on the same subnet as the storage

system.

Deploy the Storage Center