Deployment Guide

b) Type a IPv6 management address for each storage controller in the associated fields.

c) Type the IPv6 address prefix in the Prefix field.

d) Type the IPv6 gateway address the Gateway Address field.

Network Settings

a) Type the domain name of the management network in the Domain Name field.

b) Type the DNS server addresses of the management network in the DNS Server and Secondary DNS Server fields.

c) (Optional) Type a secondary DNS server addresses of the management network in the Secondary DNS Server fields.

3. To proceed:

• If you are connected to a Data Collector, click Next. The Security page opens.

• If you are connected directly to a Storage Center, click Finish. The Configure tab opens.

Set the Password and Finish the Installation

If you are connected to a Data Collector, the Security tab opens after configuring the network settings.

Prerequisites

This section applies only if you are connected to a Data Collector.

Steps

1. Type a password for the Storage Center Admin user in the New Password field.

2. Retype the password for the Storage Center Admin user in the Confirm Password field.

3. Click Next.

The Storage Center Summary page opens.

4. Verify that the Storage Center settings are correct.

5. If the configuration information is correct, click Next.

If the configuration information is incorrect, click Back and provide the correct information.

NOTE:

After you click the Next button, the configuration cannot be changed until after the Storage Center is fully

deployed.

The Installation Complete page opens.

6. Click Finish.

The Configure tab of the Initialize Storage Center wizard is displayed.

Configure Tab

Use the Configure tab to deploy the Storage Center and configure additional Storage Center settings.

Deploy the Storage Center

The Initialize Storage Center wizard performs system deployment tasks.

Steps

1. Wait until all of the Storage Center deployment tasks are complete.

2. Click Next.

Enter Key Management Server Settings

Specify key management server settings, such as hostname and port.

Steps

1. In the Hostname field, type the host name or IP address of the key management server.

2. In the Port field, type the number of a port with open communication with the key management server.

3. In the Timeout field, type the amount of time in seconds after which the Storage Center should stop attempting to reconnect to the

key management server after a failure.

Deploy the Storage Center