Deployment Guide
Record System Information
Use the worksheet found in the appendix of this guide to record the information you will need to install the SCv3000 and SCv3020
system.
Deploying the Storage Center Using Unisphere
Use the Initialize Storage Center wizard in Unisphere to discover and configure Storage Centers.
If you do not have access to Unisphere, use the Unisphere Discovery Utility to discover and configure Storage Centers.
Open the Initialize Storage Center Wizard
Perform the following steps to open the Initialize Storage Center wizard.
Steps
• To access the Initialize Storage Center wizard from the Data Collector:
a) Open a web browser.
b) Type the address of the Data Collector in the browser using the following format:
https://Data Collector host name or IP address:3033/
NOTE:
The computer accessing the Data Collector must be on the same subnet as the Data Collector.
c) Type the user name and password of a Data Collector user in the User Name and Password fields.
d) Click Log In.
The web browser connects to the Data Collector and displays the Storage Manager Home page.
e) From the Unisphere Home page, click (New), and select Initialize Storage Center.
The Initialize Storage Center wizard opens and the Introduction page is displayed.
• If the Storage Center is installed on a network with DHCP enabled, you can access the Initialize Storage Center wizard by connecting
directly to a Storage Center.
a) Open a web browser.
b) Type the service tag or IP address of the Storage Center in the browser using the following format:
https://Storage Center service tag or IP address/
c) Type Admin in the User Name field.
d) Type mmm in the Password field.
e) Click Log In.
The web browser connects to the Storage Center and the Change Password dialog box is displayed in the Unisphere interface.
f) Type mmm in the Current Password field.
g) Type a new password for the Admin user in the New Password and Confirm New Password fields.
h) Click OK.
The Initialize Storage Center wizard opens and the Welcome page is displayed.
• If you do not have access to a Data Collector and you are unable to connect directly to a Storage Center, use the Unisphere Discovery
Utility to discover and initialize a Storage Center.
Install Tab
Use the Install tab to configure the management network and security settings on a Storage Center.
Introduction to Storage Center Initial Configuration
The Storage Center Initial Configuration page provides a list of prerequisite actions that must be performed and information that is
required to configure a
Storage Center.
Steps
1. Make sure the prerequisites that are listed on the Storage Center Initial Configuration page are met.
2. Make sure the information that is required to configure the Storage Center is gathered.
3. Click Next. The Discover Storage Centers page is displayed and it lists the unconfigured Storage Centers.
Deploy the Storage Center
55