Deployment Guide

Figure 64. Attach Label to Cable

2. Wrap the label around the cable until it fully encircles the cable. The bottom of each label is clear so that it does not obscure

the text.

Figure 65. Wrap Label Around Cable

3. Apply a matching label to the other end of the cable.

Connect Power Cables and Turn On the Storage System

Connect power cables to the storage system components and turn on the hardware.

About this task

• If the storage system is installed without expansion enclosures, connect power cables to the storage system chassis and turn on

the storage system.

• If the storage system is installed with expansion enclosures, connect power cables to the expansion enclosure chassis and turn

on the expansion enclosures as described in the Dell Storage Center SCv2000/SCv2020 Storage System Getting Started

Guide. After the expansion enclosures are powered on, connect power to the storage system chassis and turn on the storage

system.

Steps

1. Make sure that the power switches are in the OFF position before connecting the power cables.

2. Connect the power cables to both power supply/cooling fan modules in the storage system chassis and secure the power

cables firmly to the brackets using the straps provided.

Connect the Back-End Cabling and Connect the Power