Deployment Guide

Figure 13. SCv2000/SCv2020 Storage System Drive Indicators
Item Control/Feature Indicator Code
1 Drive activity indicator
• Blinking green: Drive activity
• Steady green: Drive is detected and has no faults
2 Drive status indicator
• Off: Normal operation
• Blinking amber (on 1 sec. / off 1 sec.): Drive identification is enabled
• Blinking amber (on 2 sec. / off 1 sec.): Hardware/firmware fault
• Steady amber: Drive is safe to remove
SCv2000/SCv2020 Storage System Drive Numbering
Drives are numbered from left to right in the SCv2000/SCv2020 storage system.
The Storage Center identifies drives as XX-YY, where XX is the unit ID of the storage system, and YY is the drive position inside the
storage system.
• The SCv2000 holds up to 12 drives, which are numbered from left to right in rows starting from 0 at the top-left drive.
Figure 14. SCv2000 Storage System Drive Numbering
• The SCv2020 holds up to 24 drives, which are numbered from left to right starting from 0.
Figure 15. SCv2020 Storage System Drive Numbering
SC100/SC120 Expansion Enclosure Overview
The SC100 is a 2U expansion enclosure that supports up to 12 3.5‐inch hard drives installed in a four‐column, three-row
configuration. The SC120 is a 2U expansion enclosure that supports up to 24 2.5‐inch hard drives installed vertically side by side.
An SC100/SC120 expansion enclosure ships with two redundant power supply/cooling fan modules and two redundant enclosure
management modules (EMMs).
About the SCv2000/SCv2020 Storage System
21