Administrator Guide

3. Click the SupportAssist tab.
4. Disable SupportAssist. Click Turn Off SupportAssist.
5. Under Configure Update Utility, select the Enabled checkbox.
6. In the Update Utility Host or IP Address field, type the host name or IP address of the Storage Center Update Utility.
7. In the Update Utility Port field, type the port of the Storage Center Update Utility. The default port is 9005.
8. Click OK.
Configure SupportAssist Settings with Unisphere
Use Unisphere to connect to the Storage Center and configure the SupportAssist settings.
About this task
NOTE: For more information about using Unisphere, refer to the Unisphere and Unisphere Central for SC Series
Administrator’s Guide .
Steps
1. If you are using Unisphere Central, select a Storage Center from the drop-down list in the left navigation pane.
2. Click Summary.
The Summary view is displayed.
3. Click (Settings).
The Storage Center Settings dialog box opens.
4. Click the SupportAssist tab.
5. Disable SupportAssist. Click Turn Off.
6. Under Use Update Utility, select the Enabled checkbox.
7. In the Update Utility Host or IP Address field, type the IP address of the Storage Center Update Utility.
8. In the Update Utility Port field, type the port of the Storage Center Update Utility.
9. Click OK.
Update Storage Center Software Using a Distro
Directory
Use these instructions to update Storage Center software using a distro directory.
Prerequisites
CAUTION:
Recovery of Storage Center software or system state is not possible without assistance from technical
support. Dell EMC recommends backing up the system before performing a Storage Center software update.
About this task
NOTE:
For more information about using Storage Manager or Unisphere, refer to the Dell EMC Storage Manager
Administrator’s Guide or the Unisphere and Unisphere Central for SC Series Version Administrator’s Guide ,
respectively.
Steps
1. Start the Update Utility.
Storage Center Update Utility
7