Reference Guide

Table 3. NTP, SMTP, and Proxy Servers

NTP server IPv4 address ____ . ____ . ____ . ____

SMTP server IPv4 address ____ . ____ . ____ . ____

Backup SMTP server IPv4 address ____ . ____ . ____ . ____

SMTP server login ID _____________________

SMTP server password _____________________

Proxy server IPv4 address ____ . ____ . ____ . ____

Fibre Channel Zoning Information

For a storage system with Fibre Channel front-end ports, record the physical and virtual WWNs of the Fibre Channel ports in

Fault Domain 1 and Fault Domain 2. This information is displayed on the Review Front-End page of the Discover and Configure

Uninitialized Storage Centers wizard. Use this information to configure zoning on each Fibre Channel switch.

Table 4. Fault Domain WWNs

Physical WWNs in Fault Domain 1

Physical WWN of storage controller 1: port 1 _____________________

Physical WWN of storage controller 2: port 1 _____________________

(4-port HBA only) Physical WWN of storage controller 1: port 3 _____________________

(4-port HBA only) Physical WWN of storage controller 2: port 3 _____________________

Virtual WWNs in Fault Domain 1

Virtual WWN of storage controller 1: port 1 _____________________

Virtual WWN of storage controller 2: port 1 _____________________

(4-port HBA only) Virtual WWN of storage controller 1: port 3 _____________________

(4-port HBA only) Virtual WWN of storage controller 2: port 3 _____________________

Physical WWNs in Fault Domain 2

Physical WWN of storage controller 1: port 2 _____________________

Physical WWN of storage controller 2: port 2 _____________________

(4-port HBA only) Physical WWN of storage controller 1: port 4 _____________________

(4-port HBA only) Physical WWN of storage controller 2: port 4 _____________________

Virtual WWNs in Fault Domain 2

Virtual WWN of storage controller 1: port 2 _____________________

Virtual WWN of storage controller 2: port 2 _____________________

(4-port HBA only) Virtual WWN of storage controller 1: port 4 _____________________

(4-port HBA only) Virtual WWN of storage controller 2: port 4 _____________________

Using SupportAssist

SupportAssist is a support tool that collects and stores system state information and transmits it to technical support.

SupportAssist provides service requests, automatic support case creation based on event alerting, automatic health checks,

remote software updates, real-time troubleshooting, and customer support. After installation and setup, SupportAssist sends

the initial configuration information for the Storage Center to technical support.

NOTE:

SupportAssist system state information is only used for diagnostic purposes and customer support. The

SupportAssist Agreement must be accepted and SupportAssist must be enabled to set up automatic software updates and