Reference Guide

Output
For each Replay, the following information is output to the console in table format.
Output Description
Index Shows index of the Replay prole.
Name Shows name of the Replay prole.
Type Shows type for the Replay prole.
numRules Shows number of rules associated with the Replay prole.
NumVolumes Shows number of volumes using the Replay prole.
Schedule Shows schedule(s) for the Replay prole.
server addhba
Description
On Storage Center 5.0 and later, congures a new HBA for an existing server in the Storage Center, thus adding another storage path for
the server that can be mapped and managed through the Storage Center.
Usually, the Storage Center rst discovers a server and its ports/HBAs through a transport protocol. This discovery happens before an
HBA can be congured for use. The –manual option ag overrides this dependency and allows HBAs to be congured before they are
discovered. If the –manual ag is provided, then the –porttype option is also required and all specied WWNs must (upon discovery)
match the transport type of the respective HBA. If the –manual ag is omitted, then –porttype is ignored.
NOTE
: Actual values discovered through a transport protocol take precedence over this command. Therefore, the Command
Utility evaluates discovered values before applying changes to the Storage Center.
This command is rejected for all requested WWNs if:
• It does not identify an existing server by –name or by –index.
• A requested WWN duplicates an already congured HBA.
• A requested WWN has not been discovered and the –manual ag is omitted.
• –manual ag is provided but the –porttype option is omitted.
• Requested WWN matches a discovered HBA whose transport type diers from the requested –porttype.
• Requested WWN is invalid for the actual and/or requested transport type. Specically, for Fibre Channel a WWN must consist of 16
hexadecimal digits.
Format
server addhba {–name string | –index integer} –WWN string,…,string {options}
Options
–h
48
Command Reference