Owners Manual

Steps
1 Loosen the screw securing the iDRAC port card holder to the system board.
2 Pull the iDRAC port card to disengage it from the iDRAC port card connector on the system board, and remove the card from the
chassis.
Figure 26. Removing and installing the iDRAC port card
1
screw 2 iDRAC port
3 iDRAC port card board 4 SD vFlash media card slot
5 tabs on the iDRAC port 6 slots on the chassis
7 iDRAC port card connector 8 iDRAC port card holder
Next steps
1 Install the iDRAC port card.
2 Install the cooling shroud.
3 If disconnected, reconnect the network cable.
4 Follow the procedure listed in the After working inside your system section.
Installing the optional iDRAC port card
Prerequisites
CAUTION
: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Installing and removing system components 75