Owners Manual

2. Place your finger between the securing tabs at the negative side of the battery connector, and lift the battery out of the
socket.
Figure 36. Removing the system battery
a. system battery
b. system battery slot
3. To install a new system battery, hold the battery with the "+" facing up and slide it under the securing tabs.
4. Press the battery into the connector until it snaps into place.
Figure 37. Installing the system battery
a. system battery
b. system battery slot
Next steps
1. Install the cooling shroud.
2. Follow the procedure listed in the After working inside your system section.
3. While booting, press F2 to enter System Setup and ensure the battery is operating properly.
4. Enter the correct time and date in the System Setup Time and Date fields.
5. Exit System Setup.
Related references
Safety instructions on page 48
Jumpers and connectors on page 111
Related tasks
Before working inside your system on page 49
After working inside your system on page 49
Hard disk drive backplane
The Dell Storage NX3330 system supports 2.5 inch (x4) SAS/SATA backplane.
Installing and removing system components
93