Owners Manual

Figure 31. Installing a processor
1.
socket-release lever 1 2. pin–1 corner of the processor
3. processor 4. slot (4)
5. processor shield 6. socket-release lever 2
7. processor socket 8. tab (4)
Next steps
NOTE:
Ensure that you install the heat sink after you install the processor. The heat sink is necessary to maintain proper
thermal conditions.
1. Install the heat sink.
2. If removed, reinstall the PCIe expansion card riser.
3. If disconnected, reconnect the cables to the expansion card(s).
4. Install the cooling shroud.
5. Follow the procedure listed in the After working inside your system.
6. While booting, press F2 to enter System Setup and verify that the processor information matches the new system
configuration.
7. Run the system diagnostics to verify that the new processor operates correctly.
Related references
Safety instructions on page 48
Related tasks
Before working inside your system on page 49
Installing and removing system components
87