Owners Manual

2. Align the captive screws on the card with the captive screw sockets on the system board.
3. Press the touch points on the card until the card connector is firmly seated on the system board connector.
4. Tighten the captive screws to secure the NDC to the system board.
Figure 28. Installing the NDC
1.
captive screw socket (2) 2. connector on the system board
3. captive screw (2) 4. touch point (2)
5. network daughter card (NDC) 6. back panel slot for Ethernet connectors
Next steps
1. If applicable, install the expansion card(s) in the expansion card riser 2.
2. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 48
Related tasks
Before working inside your system on page 49
After working inside your system on page 49
Processors and heat sinks
Use the following procedures when:
● Removing and installing a heat sink
● Installing an additional processor
● Replacing a processor
82
Installing and removing system components