Owners Manual

Figure 27. Removing and installing the NDC
1.
captive screw socket (2) 2. connector on the system board
3. captive screw (2) 4. touch point (2)
5. NDC 6. back panel slots for Ethernet connectors
Related references
Safety instructions on page 48
Related tasks
Before working inside your system on page 49
Installing the network daughter card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If applicable, remove the expansion card riser 1.
4. Keep the Phillips #1 screwdriver ready.
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
Steps
1. Orient the network daughter card (NDC) so that the Ethernet connectors fit through the slot in the back panel.
Installing and removing system components
81