Owners Manual

Figure 26. Removing and installing the integrated storage controller card
1.
integrated storage controller cable 2. integrated storage controller card
3. integrated storage-controller card connector on the
system board
4. integrated storage controller card holder
Next steps
1. Replace the expansion-card riser 1.
2. Replace the cooling shroud.
3. Complete the tasks listed in the After working inside your system section in this document.
Related references
Safety instructions on page 48
Related tasks
Before working inside your system on page 49
After working inside your system on page 49
Installing integrated storage controller card
Prerequisites
1. Ensure that you read the Safety instructions section in this document.
2. Complete the tasks listed in the Before working inside your system section in this document.
3. Remove the cooling shroud.
4. Remove the expansion card riser 1.
5. Keep the #2 Phillips screwdriver handy.
Installing and removing system components
79