Owners Manual

NOTE: The expansion-card riser 1 and the x16 link on the riser 2 slot can be used only when both the processors are

installed.

Steps

1. Holding the touch points, lift the expansion-card riser from the riser connector on the system board.

Figure 23. Removing and installing the expansion card riser 1

a. expansion-card riser 1

b. connector

c. riser guide pin

Figure 24. Removing and installing the expansion card riser 3

a. connector

b. expansion card riser 3

c. expansion card release latch

2. If applicable, remove or install an expansion card on the riser.

3. Replace the expansion-card riser.

Installing and removing system components