Owners Manual

CAUTION: The display module connector is a ZIF (zero insertion force) connector. Ensure that the locking
tab on the connector is released before removal and insertion. The locking tab must be engaged after
insertion.
5. Connect the display module cables to the control panel board.
Figure 44. Installing the VGA module
1.
screw 2. VGA module cable
3. VGA module 4. control panel
Next steps
Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 48
Related tasks
After working inside your system on page 49
System board
Removing system board
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
CAUTION: If you are using the Trusted Platform Module (TPM) with an encryption key, you may have to create a
recovery key during program or System Setup. Enure to create and safely store this recovery key. If you replace
102 Installing and removing system components