Owners Manual

Figure 43. Removing the VGA Module
1. screw 2. VGA module cable
3. VGA module 4. control panel
Related references
Safety instructions on page 48
Related tasks
Before working inside your system on page 49
Installing the VGA module
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: This procedure applies only to the eight hard drive system.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Keep the Philips #2 screwdriver ready.
Steps
1. Push the VGA module into the chassis and align the threaded screw hole on the VGA module with the screw hole on the
chassis.
2. Replace the screw (at the bottom of the chassis) that secures the VGA module to the chassis.
3. Replace the control panel.
4. Connect the VGA module cable to the VGA module.
Installing and removing system components
101