Owners Manual

Figure 44. Removing and installing the cable retention bracket

a. alignment pin (2)

b. tab

c. cable retention bracket

Next steps

1. Replace the cable retention bracket. See Installing the cable retention bracket section in this document.

2. Complete the tasks listed in After working inside your system section in this document.

Related References

Safety instructions on page 46

Related tasks

Before working inside your system on page 47

After working inside your system on page 47

Installing the cable retention bracket on page 98

Installing the cable retention bracket

Prerequisites

1. Ensure that you read the Safety instructions section in this document.

2. Complete the tasks listed in Before working inside your system section in this document.

3. Remove the cooling shroud.

4. Remove the PCIe card holder.

CAUTION:

Many repairs may only be done by a certified service technician. You should only perform troubleshooting and

simple repairs as authorized in your product documentation, or as directed by the online or telephone service and

support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow

the safety instructions that are shipped with your product.

Steps

1. Align the cable retention bracket with the alignment pins on the chassis.

2. Slide the cable retention bracket along the chassis wall until the tab clicks and locks the slots.

3. Place all cables to be routed in the cable retention bracket.

Next steps

1. Install the PCIe card holder.

2. Install the cooling shroud.

Installing and removing system components