Owners Manual

Figure 58. Removing and installing the I/O panel —NX3230
1.
I/O panel cable 2. hard-drive backplane
3. screw (3) 4. I/O panel
5. chassis
Next steps
1. Replace the I/O panel. See the Installing the I/O Panel section in this document.
2. Complete the tasks listed in the After working inside your system section in this document.
Related References
Safety instructions on page 46
Related tasks
Before working inside your system on page 47
Removing HDD backplane on page 107
Installing the I/O panel on page 116
After working inside your system on page 47
Installing the I/O panel
Prerequisites
1. Ensure that you read through the Safety instructions section in this document.
2. Complete the tasks listed in Before working inside your system section in this document.
3. Keep the T15 Torx screw driver handy.
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
116 Installing and removing system components