Deployment Guide

flow-misses drop

Prevents flow misses (flows that do not reach their intended destination) from being copied to the

controller.

Syntax

flow-misses drop

To copy flow misses to the controller, use the no flow-misses drop on the

specific OF instance.

Defaults none

Command

Modes

OPENFLOW INSTANCE

Command

History

Version Description

9.7(0.0) Introduced on the S5000, S6000-ON, and Z9500.

9.3(0.0) Introduced on the S6000.

9.2(0.2) Introduced on the S4820T and MXL.

9.2(0.2) Introduced on the Z9000 and S4810.

Usage

Information

By default, flow misses are copied to the controller. To disable this feature on an

OF instance, configure the controller to drop flow misses instead of copying them

to the controller by using the flow-misses drop command.

Commands

shutdown — Enables or disables the OpenFlow instance.

show openflow — Displays general information about OpenFlow instances.

controller — Specifies the OpenFlow controller configuration that the OpenFlow

instance uses to establish a connection.

interface-type

Specify the type of interface (port, VLAN, or any) for the OpenFlow instance.

Syntax

interface-type {any|port|vlan}

To remove the flow-miss behavior, use the no interface-type {any|port|

vlan}command.

Defaults

port

Parameter

any Enter the keyword any to enable configuration of physical

interfaces, LAGs, and VLANs on the selected OF instance.

port Default. Enter the keyword port to enable configuration of

LAGs or physical interfaces on the selected OF instance.

vlan Enter the keyword vlan to enable configuration of VLANs on

the selected OF instance.