Deployment Guide

Usage Information To display general information such as version, capabilities, and supported actions, use the show openflow
command.
Related Commands openflow of-instance — Creates or modifies an OpenFlow instance.
show openflow flows
Display detailed information about OpenFlow instances.
Syntax
show openflow flows of-instance of-id [table{acl|mac|route|vlan}]flow-id flow-
id
Parameter
of-instance of-id Enter the keywords of-instance followed by the OF instance ID to display details of
all flows installed for the specified OF instance. The of-id ranges from 1 to 8.
table acl | mac |
route | vlan flow-id
flow-id
Enter the keyword table followed by the table type and the keywords flow-id
followed by the flow ID to display details for the specified flow. The flow-id ranges
between 0 to 65535.
acl
Display ACL table information.
mac
Display MAC table information.
route
Display routing table information.
vlan
Display VLAN table information.
Defaults None
Command Modes EXEC
Command History
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11(0.0) Added new “meta data” parameter, and added new action type “Implicit Permit” in the
flow display.
9.10(0.1) Introduced on the S4048T-ON and S6010-ON.
9.9(0.0) Introduced on the C9010.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON
9.7(0.0) Introduced on the S5000, S6000-ON, and Z9500.
9.3(0.0) Introduced on the S6000.
9.2(0.0) Introduced on the S4820T and MXL.
9.1(0.0) Introduced on the S4810.
Example Output in
9.11(0.0)
Instance: 1, Table: acl, Flow: 25, Cookie: 0xc83c736900000000
Priority: 22800, Internal Priority: 22800
Up Time: 0d 00:12:21, Hard Timeout: 0 seconds
Idle Timeout: 0 seconds, Internal Idle Timeout: 0 seconds
Packets: 0, Bytes: 0
Match Parameters:
Valid Match: InPort
OpenFlow Commands 57