Deployment Guide

Command History
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S4048T-ON and S6010-ON.
9.9(0.0) Introduced on the C9010.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON
9.7(0.0) Introduced on the S5000, S6000-ON, and Z9500.
9.3(0.0) Introduced on the S6000.
9.2(0.0) Introduced on the S4820T and MXL.
9.1(0.0) Introduced on the S4810.
Example (show
openflow)
Dell#show openflow
Manufacturer : Dell
Hardware Desc : OpenFlow switch HW ver. 1.0
Software Desc : OpenFlow switch SW ver. 1.0 and 1.3
Capabilities : port,table,flow,queue
Actions : output,enqueue,strip-vlan,set-vlan,set-pcp,set-smac,set-dmac,set-tos
Default VLAN : 0 (configured), 4093 (used)
Source Suppression : enabled
Reconnect Timer : 120
Recover Timer : 30
Dell#
Example (show
openflow of-
instance)
Dell#show openflow of-instance 2
Instance : 2
Admin State : Up
OF Version : V1-3
Interface Type : Vlan
DP Id : 00:02:00:01:e8:8b:3d:c1
Forwarding Tbls : acl,mac,route
Vlan Learn : enabled
L2 MacLearn Mode: enabled
Flow map :
EchoReq interval: 15 seconds
Connect interval: 15 seconds
Number of Flows : 10 (acl:10)
Packets (acl) : 8820
Bytes (acl) : 599760
Fail mode : secure
Flow misses : copy-to-controller
Controller 1 : TCP,10.11.54.60/6633, rcv/sndbuf 2000/2000, connected (equal)
Controller 2 : -
Port List :
Dell(conf-of-instance-2)#show config
openflow of-instance 2
controller 1 10.11.54.60 tcp
interface-type vlan
multiple-fwd-table enable
of-version 1.3
dynamic-vlan-learn enable
l2-maclearn-mode enable
no shutdown
56
OpenFlow Commands