Deployment Guide

Dell(conf-if-gi-1/31)#of-instance 1

Dell(conf-if-gi-1/31)#

Dell(conf)#interface gigabitethernet 1/7

Dell(conf-if-gi-1/7)#of-instance 1

Dell(conf-if-gi-1/7)#interface gigabitethernet 1/31

Dell(conf-if-gi-1/31)#of-instance 1

Dell(conf-if-gi-1/31)#

Dell(conf)#interface tengigabitethernet 1/7/1

Dell(conf-if-te-1/7/1)#of-instance 1

Dell(conf-if-te-1/7/1)#interface tengigabitethernet 1/31/1

Dell(conf-if-te-1/31/1)#of-instance 1

Dell(conf-if-te-1/31/1)#

Dell(conf)#interface tengigabitethernet 1/7

Dell(conf-if-te-1/7)#of-instance 1

Dell(conf-if-te-1/7)#interface tengigabitethernet 1/31

Dell(conf-if-te-1/31)#of-instance 1

Dell(conf-if-te-1/31)#

Usage Information

NOTE: On the C9000 Series, Dell Networking recommends configuring OpenFlow in default

forwarding-mode only.

To enable OpenFlow, associate a port or a VLAN to an OF instance. Associate ports and VLANs when you create

the OF instance and it is disabled using the shutdown command.

Before applying the interface, the software checks to ensure that none of the following apply:

• L2 or L3 more

• LACP is configured

• Included in a LAG

• Included in another OF instance

• Not a destination port for a port monitoring session

If any of the above apply, the interface is not applied to the OF instance.

LAGs or port-channel interfaces are supported as OF ports or OF VLAN members on OpenFlow.

By default, all ports are available for legacy functionality.

The following features are not supported on physical interfaces associated with an OpenFlow instance:

• Dot1x

• Ethernet

• GVRP

• IPv4

• IPv6

• MAC

• MTU

• Port-channel protocols

• Spanning-tree protocols

• Switchport

The following features are not supported on LAGs associated with an OpenFlow instance:

• Ethernet

• GVRP

• IPv4

OpenFlow Commands