Deployment Guide

Command Modes CONFIGURATION
Command History
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S4048T-ON and S6010-ON.
9.9(0.0) Introduced on the C9010.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON
9.7(0.0) Introduced on the S5000, S6000-ON, and Z9500.
9.3(0.0) Introduced on the S6000.
9.2(0.2) Introduced on the S4820T and MXL.
9.2(0.2) Introduced on the S4810.
Usage Information
• You cannot configure an IP address as an OF VLAN.
• You cannot add an existing VLAN to an OpenFlow instance.
• You cannot enable STP if you have configured an OF VLAN.
• You cannot assign the default VLAN as an OF VLAN.
Related Commands openflow of-instance — Creates or modifies an OpenFlow instance.
L2-maclearn-mode enable
Enables the L2 MAC — learning mode for an OF instance. This command will allow MAC flows to be installed by the switch when dynamic
MAC learning is enabled on the same OF instance.
Syntax
l2–maclearn—mode enable
To disable this feature use the no version of the command: no l2–maclearn—mode enable
Defaults Disabled
Command Modes OPENFLOW INSTANCE
Command History
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11(0.0) Introduced on all Dell Networking OS platforms.
Example
Dell#show openflow of-instance 2
Instance : 2
Admin State : Up
OF Version : V1-3
Interface Type : Vlan
DP Id : 00:02:00:01:e8:8b:3d:c1
Forwarding Tbls : acl,mac,route
Vlan Learn : enabled
L2 MacLearn Mode: enabled
Flow map :
EchoReq interval: 15 seconds
48 OpenFlow Commands