Deployment Guide

port Default. Enter the keyword port to enable configuration of LAGs or physical interfaces
on the selected OF instance.
vlan Enter the keyword vlan to enable configuration of VLANs on the selected OF instance.
NOTE: You must associate the OF instance with the VLAN when you create
the VLAN.
Command Modes OPENFLOW INSTANCE
Command History controller — Specifies the OpenFlow controller configuration that the OpenFlow instance uses to establish a
connection.
Version Description
9.10(0.1) Introduced on the S4048T-ON and S6010-ON.
9.9(0.0) Introduced on the C9010.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON
9.7(0.0) Introduced on the S5000, S6000-ON, and Z9500.
9.3(0.0) Introduced on the S6000.
9.2(0.0) Introduced on the S4820T and MXL.
9.1(0.0) Introduced on the S4810.
Example (VLAN
interface type)
Dell(conf)#openflow of-instance 1
Dell(conf-of-instance-1)#interface-type vlan
Dell(conf-of-instance-1)#
Usage Information Dell Networking does not recommend selecting any for the interface-type unless both OF ports and OF
VLANs are required in a single instance. If you select any is selected for the interface-type, the number of
available ACL flows is reduced by half.
Disable legacy LLDP on of-ports to avoid conflicts with the controller’s version of LLDP.
Dell Networking does not recommend configuring global STP instances on ports using both legacy VLANs and OF
VLANs.
Related Commands openflow of-instance — Creates or modifies an OpenFlow instance.
interface vlan
Creates a VLAN and associates it with an OpenFlow instance.
Syntax
interface vlan vlan-id of-instance of-id
Parameters
vlan-id Enter the keyword vlan then the VLAN ID to specify a VLAN. The range is from 1 to
4096.
of-id Enter the keyword of-instance then the OF ID to specify an OF instance. The range
is from 1 to 8.
OpenFlow Commands 47