Deployment Guide

Usage Information L2 flow-mapping is not supported on OpenFlow instances with an interface-type of port.
Related Commands openflow of-instance — Creates or modifies an OpenFlow instance.
flow-misses drop
Prevents flow misses (flows that do not reach their intended destination) from being copied to the controller.
Syntax
flow-misses drop
To copy flow misses to the controller, use the no flow-misses drop on the specific OF instance.
Defaults none
Command Modes OPENFLOW INSTANCE
Command History
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S4048T-ON and S6010-ON.
9.9(0.0) Introduced on the C9010.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON
9.7(0.0) Introduced on the S5000, S6000-ON, and Z9500.
9.3(0.0) Introduced on the S6000.
9.2(0.2) Introduced on the S4820T and MXL.
9.2(0.2) Introduced on the S4810.
Usage Information By default, flow misses are copied to the controller. To disable this feature on an OF instance, configure the
controller to drop flow misses instead of copying them to the controller by using the flow-misses drop command.
Related Commands
• shutdown — Enables or disables the OpenFlow instance.
• show openflow — Displays general information about OpenFlow instances.
• controller — Specifies the OpenFlow controller configuration that the OpenFlow instance uses to establish a
connection.
interface-type
Specify the type of interface (port, VLAN, or any) for the OpenFlow instance.
Syntax
interface-type {any|port|vlan}
To remove the flow-miss behavior, use the no interface-type {any|port|vlan}command.
Defaults
port
Parameter
The following is a list of the Dell Networking OS version history for this command.
any Enter the keyword any to enable configuration of physical interfaces, LAGs, and VLANs
on the selected OF instance.
46 OpenFlow Commands