Deployment Guide

table-mod
Enable debugging for table-mod packets (V1.3).
vendor
Enable debugging for vendor packets.
of-instance {of-id} Enter the keywords of-instance followed by the OF instance ID. The range is 1 to 8.
Defaults None
Command Modes EXEC
Command History
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S4048T-ON and S6010-ON.
9.9(0.0) Introduced on the C9010.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON
9.7(0.0) Introduced on the S5000, S6000-ON, and Z9500. Packet instances corresponding to
Version 1.3 are included.
9.3(0.0) Introduced on the S6000.
9.2(0.0) Introduced on the S4820T and MXL.
9.1(0.0) Introduced on the S4810.
Usage Information To enable debugging for all packets, use the debug openflow packets packet-type all command.
dynamic–vlan–learn enable
This command enables learning on all VLANs configured in the OF-instance.
Syntax
dynamic–vlan—learn enable
To disable this feature use the no version of the command: no dynamic–vlan—learn enable
Defaults Disabled
Command Modes OPENFLOW INSTANCE
Command History
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11(0.0) Introduced on all Dell Networking OS platforms.
Example
Dell#show openflow of-instance 2
Instance : 2
Admin State : Up
OF Version : V1-3
Interface Type : Vlan
DP Id : 00:02:00:01:e8:8b:3d:c1
Forwarding Tbls : acl,mac,route
Vlan Learn : enabled
L2 MacLearn Mode: enabled
OpenFlow Commands 43