Deployment Guide

• openflow vlan

• reconnect-timer

• recover-timer

• show openflow

• show openflow flows

• show openflow groups

• shutdown (OpenFlow Instance)

• src-suppression

SDN Command Modes

To navigate and launch various CLI modes, use the following commands.

CONFIGURATION Mode

In EXEC Privilege mode, use the configure command to enter CONFIGURATION mode and configure routing protocols and access

interfaces.

To enter CONFIGURATION mode:

1 Verify that you are logged in to EXEC Privilege mode.

2 Enter the configure command. The prompt changes to include (conf).

From this mode, you can enter INTERFACE mode by using the interface command.

EXEC Mode

When you initially log in to the switch, by default, you are logged in to EXEC mode. This mode allows you to view settings and enter EXEC

Privilege mode, which is used to configure the device.

When you are in EXEC mode, the > prompt is displayed following the host name prompt, which is “Dell” by default. You can change the

host name prompt using the hostname command.

NOTE

: Each mode prompt is preceded by the host name.

INTERFACE Mode

Use INTERFACE mode to configure interfaces or IP services on those interfaces. An interface can be physical (for example, a Gigabit

Ethernet port) or virtual (for example, the Null interface).

To enter INTERFACE mode:

1 Verify that you are logged in to CONFIGURATION mode.

2 Enter the interface command and then enter an interface type and interface number that is available on the switch.

The prompt changes to include the designated interface and slot/port number.

OPENFLOW INSTANCE Mode

To enable and configure OpenFlow instances, use OPENFLOW INSTANCE mode. For more information, refer to SDN Commands.

To enter OPENFLOW INSTANCE mode:

OpenFlow Commands