Deployment Guide

Flow Setup

This chapter describes the configuration options required to set up flows.

Sample Topology

In the following sample topology, two OF instances are shown. of-instance 1 has an interface type of port and

demonstrates ACL and L3 flows. of-instance 2 has an interface type of VLAN and demonstrates ACL, L2, LB, and L3

flows. LB and L2 flows are supported on OF VLANs only.

Figure 2. SDN Sample Topology

To display the following information, use the show running-config openflow of-instance 1 command :

NOTE: To display information using the show running-config openflow of-instance 1 command,

you must have an active connection to the OF controller.

FTOS# show running-config openflow of-instance 1

openflow of-instance 1

controller 1 10.11.205.184 tcp

flow-map l3 enable

multiple-fwd-table enable

no shutdown

FTOS# show openflow of-instance 1

Instance : 1

Admin State : Up

Interface Type : Port

DP Id : 00:01:00:01:e8:8b:1a:30

Forwarding Tbls : acl,mac,route

Flow map : l3

LB assist : disabled

EchoReq interval: 15 seconds

Connect interval: 15 seconds