User guide

©2005 Innovative Technology Center
14
VI. U SING THE VCR INSIDE THE SMART B OARD
Note: The following applies to rooms with stand-alone SMART Board.
1. Turn on the SMART Board by pressing the power button. Wait 15 second for the
board to warm up. The light next to the power button will flash while it is warming up.
2. Press the source select button until the light beside the third (bottom) choice is lit.
3. Put a tape in the VCR. The tape will play automatically.
4. Use the left hand set of up and down arrow buttons pictured above to adjust the
volume.
5. When finished viewing, press Stop on the VCR and eject the tape.
6. To return to laptop mode when finished with the VCR, press the source select button
again until the laptop light is illuminated as it is in the picture above.
VII. SMART B OARD R ESOURCES
Technical Support – call IT Engineering Services at 974-9110 or email [e-mail].
SMART Technologies, Inc. & SMART Board Software:
http://www.smarttech.com/support/software/index.asp
User Guides and FAQs: http://www.smarttech.com/support/product/sb/index.asp or
https://itc.utk.edu/technology/tec_class/
Training classes - call the Innovative Technology Center at 974-9670 or visit
https://itc.utk.edu/technology/tec_class/
Version 01/05/06
Power Button
Source Select